Configurações

A maioria das peças tem uma tela de Configurações através da qual as configurações básicas da peça podem ser modificadas.

O Lado Alvo é o lado com o qual esta peça irá interagir. O padrão é o oposto do lado do cabo em que esta peça foi colocada.

Os Ticks/Operação permitem que você configure a frequência de tique desta peça. Quanto maior, mais lento ela opera.

A Prioridade determina a ordem em que esta peça é executada dentro de um único tique de rede.

O Canal de Energia indica o canal do qual a energia deve ser consumida quando esta peça tica. Isso só é aplicável se o consumo de energia para redes estiver habilitado.

The configuration of a part can be copied to other parts using a Wrench. Shift+right-clicking a part copies it into the Wrench, and right-clicking another part pastes it. The Wrench mode picks what is copied: Copy All takes everything and only pastes onto a part of the same type, Copy Settings takes the update interval, priority, channel, side and offsets, and Copy Aspect takes the active aspect with its variable card and all aspect settings. The last two can be pasted onto any part. Only settings that you changed yourself are copied, so pasting never resets anything you left alone. Each pasted variable card consumes one blank Variable Card from your inventory, and raising the maximum offset of a part consumes Offset Enhancements.

Right-clicking with a Wrench that holds a configuration, while not pointing at a part, opens a screen that lists everything it is going to paste: the part settings, the aspect that the copied part was writing with its variable card, and every aspect setting that was changed. Anything in that list can be switched off, so that pasting leaves that part of the target alone, and the button next to the screen switches everything on or off at once. A variable card that the target part already holds is left as it is, so it costs you no blank card.